|
|
Bent
Wheelie Bar
Yes, the stock ESP Bar is a POS. It looks even worse
now! |
Broken
Servo Saver
Kimbrough Servo Saver versus Curb (10 MPH!) |
|
|
| Broken
Rear Arm
Bad Landing, Bad suspension Pin configuration |
Broken
Rear Arm
This is why you want Suspension
Pins and E-Clips |
|
|
Incinerated
ESC
It caught fire, but oddly, it still works great! FULL
STORY |
Busted
Arm
Landing on small tires is way harder on arms. |
|
|
Broken
Front Bulkhead
Stock Suspension Pins Strike Again!
It slid out half way, then bent severely after crashing into
a wall. |
Broken
Caster Block
Another bloody Pin!!! These are the bane of my existance.
They are nearly all replaced now though. |
|
|
| Burnt
Brush
This is the result of a treacherous 7 minute hill-climb with
a 12-turn armature. |
Broken
Body Mount
Mostly the result of working on the Pede upside-down on carpet. |
|
|
Broken
Armature Wire
I think some rocks got inside the can and just chewed it all
up. |
Broken
Rear Brace / Skid
Endo'd onto the lid,
and slid backward into a curb. |
|
|
Wall
of Death Damage
After falling 15 feet onto its back, somehow the
cap came off. |
Wall
of Death Damage
Also, the front shock end came off, and the caster
block broke! |
|
|
DemoPede's
Grizzly Accident
Broken Lid and Casterblock |
King's
Blown Idler Gear (Plastic)
Any motor better than stock will do this! |
|
|
Detatched
Weld
This was a defective armature that blew up on me. |
Busted
Arm
Big Brushless Air plus a bad landing. |
|
|
Yoke
Pin Slippage
This happens with the traxxas metal balls.
You have to examine them from time to time to make sure the
pin doesn't slip so far the half-shaft comes off. |
Broken
Stock Output Yoke
One of the many ways the stock yoke can fail. If they get
old enough, they will eventually break like this. |
|
|
Broke
Truck in Half
The 25mph headon with a tree loosened it up a bit before the
bad landing. Read More |
Broken
Steel Street Sport Axle
This was hopefully going to end broken axles, guess not! |
